MOMENTS_SCALAR

This is part of the function module

Calculate the moments of the distribution of input quantities

Examples

Glossary of keywords and components

Description of components

By default the value of the calculated quantity can be referenced elsewhere in the input file by using the label of the action. Alternatively this Action can be used to calculate the following quantities by employing the keywords listed below. These quantities can be referenced elsewhere in the input by using this Action's label followed by a dot and the name of the quantity required from the list below.

Quantity	Description
moment	the central moments of the distribution of values. The second central moment would be referenced elsewhere in the input file using label.moment-2, the third as label.moment-3, etc.

Compulsory keywords

POWERS

calculate the central moments of the distribution of collective variables. The \(m\)th central moment of a distribution is calculated using \(\frac{1}{N} \sum_{i=1}^N ( s_i - \overline{s} )^m \), where \(\overline{s}\) is the average for the distribution. The POWERS keyword takes a lists of integers as input or a range. Each integer is a value of \(m\). The final calculated values can be referenced using moment- \(m\).

Options

NUMERICAL_DERIVATIVES

( default=off ) calculate the derivatives for these quantities numerically

ARG

the input for this action is the scalar output from one or more other actions. The particular scalars that you will use are referenced using the label of the action. If the label appears on its own then it is assumed that the Action calculates a single scalar value. The value of this scalar is thus used as the input to this new action. If * or *.* appears the scalars calculated by all the proceeding actions in the input file are taken. Some actions have multi-component outputs and each component of the output has a specific label. For example a DISTANCE action labelled dist may have three components x, y and z. To take just the x component you should use dist.x, if you wish to take all three components then use dist.*.More information on the referencing of Actions can be found in the section of the manual on the PLUMED Getting Started. Scalar values can also be referenced using POSIX regular expressions as detailed in the section on Regular Expressions. To use this feature you you must compile PLUMED with the appropriate flag.. You can use multiple instances of this keyword i.e. ARG1, ARG2, ARG3...